The Verticality Of The Centerline Of The Thrust Ball Bearing Shaft

  The verticality of the centerline of the thrust ball bearing shaft

  When you install the thrust ball bearings and check the verticality of the shaft and the centerline of the shaft. thrust ball bearing The method is a micrometer fixed to the surface of the housing, touches the bearing raceway bearing the watch dial indicator pointer, the pointer is deflected, the shaft turning the head and shaft centerline is not vertical. The shell hole is deeper and it can also be used to test microns long. thrust ball bearing When the thrust bearing is properly installed, the seat automatically adjusts the rolling of the rolling body to ensure that the roller is located on the raceway. If installed, the bearing not only can not run properly, and with the surface will wear badly. As the shaft and housing washers and the difference is not obvious, the assembly should be careful to avoid mistakes.

  In addition, the thrust bearing ring and bearing hole should be left 0.2-0.5 mm between the gap between the installation error caused by the installation is not accurate, when the center bearing rings, run-time deviation, this gap can ensure its automatic adjustment, Avoid friction and ensure that it works properly. Otherwise, thrust ball bearing the bearing causes serious damage. When you install the thrust bearing and check the axis and the axis of the centerline of the vertical. The method is a micrometer fixed to the surface of the housing, touches the bearing raceway bearing the watch dial indicator pointer, the pointer is deflected, the shaft turning the head and shaft centerline is not vertical. The shell hole is deeper and it is also used for elongated micrometer inspection